A sliding shower door comes off its track, you lift it back into place, and you figure you're done. A lot of the time, it comes off again.
When a sliding door comes off track, it could be for several reasons. One of the most common is that the shower door hardware itself has come loose and out of alignment. Sometimes rust has begun to form in the track and on the hardware too. The hardware is the rollers (the small wheels the door rides on), the screws, and the fittings that hold and guide the door. The track is the channel the door slides in, usually along the bottom of the shower.
Oftentimes, shower doors can just be serviced. That includes inspecting the rollers and the track, cleaning them, lubricating them, and tightening and aligning as necessary.
The seal under the track is easy to miss
While I'm servicing the shower door, I'll make sure to inspect the seal at the bottom of the track, as oftentimes it has seen better days. Typically, you'll see a clear caulking used here.
Once this caulking starts to fail, it begins to let moisture in under the track. That's where I see mold start to grow, and it weakens the track's holding power to the base of the shower. In plain words, the track isn't held down as firmly as it should be. In showers around Chula Vista and the South Bay, that bottom track stays wet a lot, so that clear seal takes a beating.
This can lead to other problems, including the door coming off the track, because the shower door frame now moves. The seal is no longer holding it in place. Glass shower doors are pretty heavy, and when the frame has lost its holding power, that's a safety hazard.
How I reset the track
My best solution is to completely remove the seal at the bottom of the shower, dry it out, apply a thick bead of strong-holding sealant to reset the track, and then apply a clear bathroom seal along the track's edge to keep moisture out. A bead is just the line of sealant.
The sealant underneath the track goes on first. I let that set before I apply the sealant to the edge, so everything dries and sets uniformly. If you only run a new line of clear caulk along the edge, you haven't reset a track that's already loose. And don't use the shower until that sealant has had time to set. Check the product's instructions for how long.
What I see when people try this themselves
Typically, what people get wrong about trying to do this themselves is being thorough on each step:
- completely removing the old sealant
- completely disinfecting
- completely drying out
- applying the sealant underneath the track first and letting it set before sealing the edge
You typically will also see the clear sealant smeared on the track frame and even the shower door itself, which doesn't look professional. Oftentimes, it is a sign that there is an area that's been compromised somewhere along the way.
Send me a few photos
If your sliding shower door came off its track, or the frame feels loose, call or text (619) 815-7588 with a wide photo of the shower, close-ups of the track, the seal at the bottom, and the hardware, plus your ZIP code. I'll confirm the price before I schedule.
If the enclosure is stable and the job is resealing the shower door frame, that work is $180 labor, or +$90 as an add-on to another job on the same visit. Prices shown are labor only. Caulking typically has a materials cost of about $15 per visit, depending on the product used, which is added to your final quote. You can see that on my shower door caulking page and the pricing menu.
Servicing the hardware, or resetting a track that's come loose, isn't a set menu price. Send the photos and I'll put together a quote.
